First of all, we need to know the performance of the box. Although the temperature of the high and low temperature test chamber is not very high, the heat dissipation of the box is the first place. These environmental requirements are also applicable to other drying equipment: blast drying oven, vacuum drying. Box and so on.
The place where the equipment is installed must meet the following conditions:
1. The ambient temperature of the installation site cannot be changed too much, and the temperature difference between the cold and the hot will be affected by the high temperature box.
2, when placed, try to stay away from walls or other items, the distance is about 50cm.
3, in order to stabilize the performance and function of high and low temperature alternating box, we should choose the temperature of 15-25 degrees, the humidity can not be greater than 85% of the most suitable place, preferably placed in a good ventilation environment.
4. Some customers say that the equipment is a bit noisy, then we should consider whether the equipment is on a horizontal surface. When the equipment is placed, it should not be too inclined. Uneven force will affect the use.
5, the equipment can not be exposed to the sun, long-term exposure will make the cabinet shell temperature is too high.
6. Keep away from combustibles, explosives, chemicals, and high-temperature heat sources, which may cause safety hazards.
7. Place it in a place with little dust as much as possible. If there is too much dust, it will adhere to the parts. For example, if there is too much dust on the fan, it will not work well. A series of temperatures will affect the uniformity of the temperature inside the box and the use of the fan. life.
8, the power plug can not be too far, because the high-low temperature test box's power cord length is limited, long-term pull will short circuit the internal line of the power cord.
Concerned about surprises
Label: Installation requirements for high and low temperature test chambers
Previous: Some principles of sanitary centrifugal pump Next: The gap between China's heating system and Europe
Hydraulic Notching Machine for Angles
This machine is used for notching corner of angle steel in the tower industry.
|
|
||
|
|
||
| Times of stroke(times/minute) | 20~25 | 15~20 |
|
|
||
| Maximum Angle bar size(mm) | 140x140x12 | 200x200x20 |
Metal Notcher,Angle Notching Machine,Cnc Notching Machine,Angle Cutting And Punching Machine
Shandong EN FIN CNC Machinery Co., Ltd , https://www.sdfincncmachine.com